![]() Tried what was previosly posted switching ignition on and off 7 times on the 8th going to crank but nothing. ![]() Is there a procedure for initialising? Looked on autodata and says ignition on and off. So i can say me dad only having 1 key he has either 0 or 4. Vares said keys 0 & 4 are bad, refitted mcu to pcb still no start using bmw scanner 1.4.0, found the key not auto initialising and not recognising key. Programmed mcu with file premireD sorted for me, thanks again m8. this is a random EWS dump from this forum!!! You have to do what PremierD says! And if is not working you will have to copy dump from the key to edit and match whit EWS Here is apicture of premireD chip on my dads board: Much thanks in advance to all replies on this thread, i have learnt alot of good stuff from you guys. Now i am stuck again whats my next step please. Using pasoft BMW scanner 1.4.0, i have these fault codes:Ġ3 (03) Toleration of changing code increased, key 0Ĥ3 (067) Toleration of changing code increaed, Key 4 Now car still doesnt crank, i have left ECU off, just be on safe side. On my dads the varnish had seeped right underneath chip managed to get it off resoldered replacement chip to board. Ok I removed chip from box that premiered sent me, bit fiddly but came off. ![]() My m8 PremiereD sent me a used EWS3 box, thanks again for that m8.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |